U-Boot 1.3.4-dirty (Sep 17 2008 - 22:49:04)

DRAM:  64 MB
NAND:  64 MiB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0
TFTP from server 197.2.2.1; our IP address is 197.2.2.2
Filename 'uImage'.
Load address: 0x33000000
Loading: #################################################################
         #####################################
done
Bytes transferred = 1494420 (16cd94 hex)
## Booting kernel from Legacy Image at 33000000 ...
   Image Name:   linux
   Created:      2008-09-24   5:33:14 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1494356 Bytes =  1.4 MB
   Load Address: 30008000
   Entry Point:  30008000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux............................................................................................... done, booting the kernel.
Linux version 2.6.27-rc7-02127-g63646fc-dirty (miaofng@126.com) (gcc version 4.0.0 (DENX ELDK 4.1 4.0.0)) #55 PREEMPT Wed Sep 24 01:30:39 EDT 2008
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=00007177
Machine: SMDK2410
Memory policy: ECC disabled, Data cache writeback
CPU S3C2410A (id 0x32410002)
S3C2410: core 202.800 MHz, memory 101.400 MHz, peripheral 50.700 MHz
S3C24XX Clocks, (c) 2004 Simtec Electronics
CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: console=ttySAC0 root=/dev/mtdblock2 init=/sbin/init
irq: clearing subpending status 00000002
PID hash table entries: 256 (order: 8, 1024 bytes)
timer tcon=00500000, tcnt a509, tcfg 00000200,00000000, usec 00001e4c
Console: colour dummy device 80x30
console [ttySAC0] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 61712KB available (2704K code, 347K data, 112K init)
SLUB: Genslabs=12, HWalign=32, rder=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 50.38 BogoMIPS (lpj=125952)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 288 bytes
NET: Registered protocol family 16
S3C2410: Initialising architecture
S3C24XX DMA Driver, (c) 2003-2004,2006 Simtec Electronics
DMA channel 0 at c4800000, irq 33
DMA channel 1 at c4800040, irq 34
DMA channel 2 at c4800080, irq 35
DMA channel 3 at c48000c0, irq 36
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
NTFS driver 2.1.29 [Flags: R/W].
msgmni has been set to 120
io scheduler noop registered
io scheduler deadline registered (default)
s3c2410-uart.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2410
s3c2410-uart.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2410
s3c2410-uart.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2410
brd: module loaded
loop: module loaded
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c2410-nand s3c2410-nand: Tacls=3, 29ns Twrph0=7 69ns, Twrph1=3 29ns
NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 4 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x00000000-0x00040000 : "u-boot"
mtd: Giving out device 0 to u-boot
0x00040000-0x00400000 : "kernel"
mtd: Giving out device 1 to kernel
0x00400000-0x00800000 : "root"
mtd: Giving out device 2 to root
0x00800000-0x04000000 : "usr"
mtd: Giving out device 3 to usr
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
s3c2410-i2c s3c2410-i2c: slave address 0x10
s3c2410-i2c s3c2410-i2c: bus frequency set to 99 KHz
s3c2410-i2c s3c2410-i2c: i2c-0: S3C I2C adapter
TCP cubic registered
Initializing XFRM netlink socket
NET: Registered protocol family 17
NET: Registered protocol family 15
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing init memory: 112K
init started: BusyBox v1.10.0 (2008-09-24 23:34:10 EDT)
starting pid 299, tty '': '/etc/init.d/rcS'
Cannot run '/etc/init.d/rcS': No such file or directory

Please press Enter to activate this console.